2017-6 and 7 Grey Water Tank Install

I used a no-weld method to install my Grey Water Tank. There’s much more detail in the video that I made about it, but here are some bonus photos that might help paint a picture of how this system works.

There was no avoiding rolling around on concrete to make this happen.
The Grey Water Tank pre-install. The black ABS pipe on the left is what I am using for my drain lines, once the tank is installed.
Here’s a close-up of where the rods attach to the super strut. The strut is bolted to the bus frame. The rod goes into a nut and has washers and locking nuts to hold it in place.
Angle Iron that is coated in truck-bed liner is drilled and put in place to hold the tank. After this, more bolts!
The tank requires a vent to displace air as water volume changes in the tank. I opted to drill a hole in the floor and go up through the roof.
Here’s my expertly-marked location for the kitchen sink drain. It be hidden in this wall, so it needs to go through that 2×4.

Previous | Photos Home | Next